How to disassemble and clean the ceramic roller of the glass tempering furnace?

Recently, many users have asked about the disassembly, cleaning and installation of the roller of the tempering furnace. Here are the answers for everyone:

How to disassemble the ceramic roller of the glass tempering furnace?

The ceramic roller of the tempering furnace can only be replaced after the tempering furnace body has cooled down. When replacing the ceramic roller, at least three people should operate (one on each side, one to two in the middle). When disassembling, first remove the screws that fix the bearings, lift the ceramic roller of the tempering equipment together and put it on the ceramic roller conveyor rack, then drag the ceramic roller outward. When pulling out the ceramic roller of the tempering furnace, pay attention to the action should be gentle, and avoid collision or scratching the roller.

How to clean the ceramic roller of the tempering equipment?

Use a vacuum cleaner to clean the dust on the surface of the ceramic roller of the tempering furnace, and then use a clean, lint-free, soft white cloth soaked in softened water to wipe from the middle to both sides to clean up the dust. It is better to use distilled water or pure water to wipe the ceramic roller of the tempering equipment. Do not use alkaline cleaners or chemical agents.

What should be paid attention to when installing the ceramic roller of the tempering furnace?

When installing the ceramic roller of the tempering equipment, first place the ceramic roller conveyor frame of the tempering furnace near the location where it needs to be installed. At least three people lift one end of the ceramic roller and place it on the roller conveyor frame, slowly push it into the tempering furnace, and then install the bearing and pulley. At least three people (one on each side, one to two in the middle) lift the ceramic roller from the conveyor frame, align the bearing with the bearing hole on the roller seat plate and slowly put it in. Manually check the rotation of the ceramic roller, and ensure that it rotates flexibly and smoothly; tighten the screws to fix the bearing; pay special attention to the fact that the top thread of the bearing at the rear end of the ceramic roller cannot be pressed to the bottom of the keyway, but must be locked with the bearing thread hole.